ZX Molle Panel Installation Instructions

Compatible with SUPER73-ZX only.

Assembly Tutorial Video:

 Tools Needed

You will need a 3mm Allen Wrench to complete the installation of this accessory.

 Parts Included

• 2 molle side panels
• 4 3mm allen bolts
• 4 countersunk washers
• 4 black nylon spacers
• 2 hook & loop velcro mounting strips

Installation Process

Note: Follow these steps carefully to ensure a safe and secure installation of the ZX molle panels on your bike.

1. Panel Identification
   • Locate the left and right panels on your bike.
   • Identify each panel by the presence of a "73" logo. The left panel has the logo on the top left corner, while the right panel has it on the top right corner.
2. Prepare Nylon Black Spacers
   • Find two nylon black spacers for each panel.
   • Position the spacers behind the mounting holes on the top of the panel.
3. Mounting the Right Side Panel
   • Thread a bolt through a countersunk washer.
   • Feed the bolt through the panel and the spacer.
   • Align the bolt with the mounting point on the frame.
   • Use a 3mm Allen wrench to secure the bolt in place.
   • Repeat the process for the second mounting point on the right panel.
4. Velcro Strip for Right Side Panel
   • Feed a hook and loop velcro strip through the bottom right corner of the right panel.
   • Wrap the strip around the bike frame.
   • Tighten the velcro strip fully to secure the right panel in place.
5. Mounting the Left Side Panel
   • Thread a bolt through a countersunk washer.
   • Feed the bolt through the panel and the spacer.
   • Align the bolt with the mounting point on the frame.
   • Use a 3mm Allen wrench to secure the bolt in place.
   • Repeat the process for the second mounting point on the left panel.
6. Velcro Strip for Left Side Panel
   • Feed the last hook and loop velcro strip through the bottom left corner of the left panel.
   • Route the strip between the frame and the motor cable.
   • Wrap the strip around the bike frame.
   • Tighten the velcro strip fully to secure the left panel in place.
7. Final Checks
   • Ensure both panels are securely fastened to the bike frame.
   • Verify that the velcro strips are tightened properly.
   • Confirm that no accessory hangs below the panels, avoiding any safety risks related to contact with the rear wheel.
8. Accessories Mounting
   • With both panels secured, you are now ready to mount accessories using your new ZX molle panels.