Follow the steps below to complete the installation of your SUPER73 Cup Holder. Please note the different installation steps for bikes with and without a fender set.
Installation without a Fender:
- Place the cup holder against the mounting bracket on your bike, aligning the holes on the bracket with the holes on the cupholder.
- Place the largest washer on the smallest bold and through the mounting bracket and use the 4mm Allen wrench to fully tighten.
- Repeat the step above for the second mounting point.
*The nyloc nut is not necessary for installation without a fender.
Installation with a Fender:
- Begin by removing the downtube fender by using a 4mm Allen wrench.
- The original hardware on the downtube fender will not be needed when re-installing the fender with the cup holder. Please store the hardware in a safe place if you plan on removing the cup holder in the future.
- Add a washer to each of the two longer bolts you receive with the cupholder and use those to replace the downtube fender to its original spot.
- Hand-tighten each bolt.
- Place the cup holder onto the bolts in-frame of the downtube.
- Place a large washer on each bolt, followed by the nyloc nut and tighten using an 8mm wrench.